| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Repair/maintenance of Shift/Throttle control? https://www.smwebhead.com/phpBB3/viewtopic.php?f=11&t=15697 |
Page 1 of 1 |
| Author: | EvilZ [ Fri Sep 01, 2017 12:10 am ] |
| Post subject: | Repair/maintenance of Shift/Throttle control? |
Does anyone have a repair manual or schematic of the Morse/Teleflex/SeaStar SL3 control like the one in the link below? http://www.seastarsolutions.com/products/controls-and-cables/mechanical-dual-action/sl3-control/ I pushed in the center button for the neutral engine warm up when I was on the water last weekend, and it stuck in, leaving me able to rev the engine, but not get it in gear.....that kind of sucked... I had to disassemble the lever and poke around and was finally able to get it back in gear, but I want to see if something needs lubricating or replacing... Any assistance appreciated. Erik |
|
| Author: | EvilZ [ Mon Sep 04, 2017 7:11 pm ] |
| Post subject: | Re: Repair/maintenance of Shift/Throttle control? |
Bumping my post to hopefully find someone who has this controller, or something similar... Thanks all. |
|
| Author: | chris268 [ Mon Sep 04, 2017 8:22 pm ] |
| Post subject: | Re: Repair/maintenance of Shift/Throttle control? |
Maybe this will help, post #10 seems to be something, possible http://forums.iboats.com/forum/engine-r ... ton-sticks |
|
| Author: | EvilZ [ Mon Sep 04, 2017 9:30 pm ] |
| Post subject: | Re: Repair/maintenance of Shift/Throttle control? |
Thanks Chris - that seems like a good lead. No idea if it's the same controller, or how it all comes apart, but I suppose I don't have much to lose by ripping into it at this point... After pulling off that center bolt that holds the shift handle on, I can also see that a couple of the wires to the tilt/trim have been nicked and bare wires are exposed. Thanks again! Erik |
|
| Author: | chris268 [ Mon Sep 04, 2017 10:13 pm ] |
| Post subject: | Re: Repair/maintenance of Shift/Throttle control? |
EvilZ wrote: Thanks Chris - that seems like a good lead. No idea if it's the same controller, or how it all comes apart, but I suppose I don't have much to lose by ripping into it at this point... After pulling off that center bolt that holds the shift handle on, I can also see that a couple of the wires to the tilt/trim have been nicked and bare wires are exposed. Thanks again! Erik On my last boat, I had those wires get torn up pretty good, to where the trim failed. It was mercruiser, I was able to buy new buttons that about 6' and a factory plug. Worked well. Good luck! |
|
| Author: | EvilZ [ Sat Sep 09, 2017 11:44 am ] |
| Post subject: | Re: Repair/maintenance of Shift/Throttle control? |
In case anyone else is in need of it, I got the SL-3 installation and owner's manual from Seastar: https://drive.google.com/open?id=0B6dU2H5k110XQmNjMzlBV1RtNVU |
|
| Author: | chris268 [ Sat Sep 09, 2017 11:57 am ] |
| Post subject: | Re: Repair/maintenance of Shift/Throttle control? |
EvilZ wrote: In case anyone else is in need of it, I got the SL-3 installation and owner's manual from Seastar: https://drive.google.com/open?id=0B6dU2H5k110XQmNjMzlBV1RtNVU Thank you! |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|