www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
Trailer Jack https://www.smwebhead.com/phpBB3/viewtopic.php?f=12&t=15170 |
Page 1 of 1 |
Author: | Capt. Hoss [ Thu Sep 08, 2016 6:54 am ] |
Post subject: | Trailer Jack |
Ok this is going to sound dumb but who here has had to replace their trailer jack? I only ask because I am having to replace mine. The gear set in the old one is missing the pins that hold it in place and it has been chewing up the gears inside. I found the right jack for my trailer and it is only $41 plus shipping. I don't have the original Four Winns trailer because of the box frame design it rusted from the inside and was no longer safe to tow with. I now have a Magnus trailer with the Fulton snap ring jack. So who here has had to replace theirs |
Author: | EvilZ [ Thu Sep 08, 2016 7:49 am ] |
Post subject: | Re: Trailer Jack |
I have to replace my trailer jack every couple of years. Salt water isn't kind to them....Nowadays, I just buy them from Harbor Freight. |
Author: | GottWhat [ Thu Sep 08, 2016 9:07 am ] |
Post subject: | Re: Trailer Jack |
Boating Magazine just had a "How-To" on this very subject: http://www.boatingmag.com/changing-out- ... ongue-jack |
Author: | LVChris [ Thu Sep 08, 2016 11:14 am ] |
Post subject: | Re: Trailer Jack |
I replaced mine with one from harbor freight as well. Very simple 4 bolts and nuts. |
Author: | Capt. Hoss [ Thu Sep 08, 2016 2:25 pm ] |
Post subject: | Re: Trailer Jack |
The jack looks easy to replace as long as it has the snap ring design, and the backing plate is welded to the trailer and I don't want to have to cut it off and wield it back on. I will have to check out harbor freight as I didn't even think of them. |
Author: | 230 Mike [ Thu Sep 08, 2016 3:16 pm ] |
Post subject: | Re: Trailer Jack |
I replaced mine with a Fulton F2. I had a fabrication shop cut off the old plate and weld on a new one, then primed & painted to match. |
Author: | Jdpber [ Fri Sep 09, 2016 8:57 am ] |
Post subject: | Re: Trailer Jack |
230 Mike wrote: I replaced mine with a Fulton F2. I had a fabrication shop cut off the old plate and weld on a new one, then primed & painted to match. this is what i am going to be doing this fall/winter but it will be done by ME |
Author: | 230 Mike [ Sat Sep 10, 2016 4:13 pm ] |
Post subject: | Re: Trailer Jack |
Jdpber wrote: 230 Mike wrote: I replaced mine with a Fulton F2. I had a fabrication shop cut off the old plate and weld on a new one, then primed & painted to match. this is what i am going to be doing this fall/winter but it will be done by ME I recommend getting the new plate from Fulton. It's sold separately but it'll make your life easier. |
Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |