www.iFourWinns.com

Hi,

I have a 2006 H180 on a single axle Carlisle trailer.

the tyres are 225/75 r15 - and are fitted to six stud steel wheels.

I am trying to locate a spare wheel here in Australia.

Can anyone tell me the bolt pattern spacing (Stud Pattern - PCD) eg 6 x 139 etc? (if that makes sense?)

Peter

Quick note - I have found some information from the Four Winns Website - it says:

6 Lug 5 1/2" Bolt Pattern (6 Lug 14 cm Pattern- metric) - not sure how to relate that to PCD....

_________________
Adelaide Australia
2006 Four Winns H180
Mercuiser 4.3L

It should be 6X139.7 if you need to verify prior to purchasing wheels, then you can create a paper or cardboard template by removing a wheel and tracing the wheel or the studs. Take the template to a tire shop and compare your template to a wheel.

_________________
2000 H190 5.0GL

I am pretty sure that the stud pattern is the same as a lot of the four wheel drives eg landcruiser patrols etc. As suggested measure the distance between the opposite studs and just check before parting with some money. Also check that the hole in the center is big enough as well
hope this helps

_________________
Ardy
Adelaide South Australia
Red H180 3.0 Merc