www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
PCD - Stud Pattern - 2006 H180 single axle trailer https://www.smwebhead.com/phpBB3/viewtopic.php?f=12&t=9212 |
Page 1 of 1 |
Author: | pmencel [ Tue May 08, 2012 6:28 am ] |
Post subject: | PCD - Stud Pattern - 2006 H180 single axle trailer |
Hi, I have a 2006 H180 on a single axle Carlisle trailer. the tyres are 225/75 r15 - and are fitted to six stud steel wheels. I am trying to locate a spare wheel here in Australia. Can anyone tell me the bolt pattern spacing (Stud Pattern - PCD) eg 6 x 139 etc? (if that makes sense?) Peter Quick note - I have found some information from the Four Winns Website - it says: 6 Lug 5 1/2" Bolt Pattern (6 Lug 14 cm Pattern- metric) - not sure how to relate that to PCD.... |
Author: | Waked Up [ Fri Jun 08, 2012 8:54 pm ] |
Post subject: | Re: PCD - Stud Pattern - 2006 H180 single axle trailer |
It should be 6X139.7 if you need to verify prior to purchasing wheels, then you can create a paper or cardboard template by removing a wheel and tracing the wheel or the studs. Take the template to a tire shop and compare your template to a wheel. |
Author: | ardy [ Fri Jun 08, 2012 11:39 pm ] |
Post subject: | Re: PCD - Stud Pattern - 2006 H180 single axle trailer |
I am pretty sure that the stud pattern is the same as a lot of the four wheel drives eg landcruiser patrols etc. As suggested measure the distance between the opposite studs and just check before parting with some money. Also check that the hole in the center is big enough as well hope this helps |
Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |