www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
87 Liberator 241 fuel tank https://www.smwebhead.com/phpBB3/viewtopic.php?f=13&t=16017 |
Page 1 of 1 |
Author: | gaw951 [ Sun Jun 24, 2018 10:17 pm ] |
Post subject: | 87 Liberator 241 fuel tank |
Anyone here replace their fuel sender in an 87 Loberator? I know there are universal fit ones but I was looking at a little higher priced non adjustable ones. I don’t really want to have to take the old one out to measure then wait a week or more for the new one before I can install it, would much rather have the new part in hand when I pull the old one. I just need to know the depth of the fuel tank, I emailed four Winns already but they were only able to tell me it was a 100 gallon tank and the original manufacturer and part number for the one fuel sender installed at the factory new. |
Author: | supermanotorious [ Tue Apr 30, 2019 12:28 pm ] |
Post subject: | Re: 87 Liberator 241 fuel tank |
can you pull it and take a quick measurement, then put it back in as you wait for new pump? |
Author: | LouC [ Thu May 02, 2019 7:42 am ] |
Post subject: | Re: 87 Liberator 241 fuel tank |
If you have the full hatch for access you can measure it with the tank in place in most cases. Probably an aluminum tank with 4 welded on tabs that get screwed into wood strips that are attached to the stringers. On mine those strips were all rotted so I replaced them and the supports under the hatch with mahogany which is much more rot resistant that the cheap pine they used... |
Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |