| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| New Magma Kettle Grill Mounting Question https://www.smwebhead.com/phpBB3/viewtopic.php?f=22&t=11746 |
Page 1 of 1 |
| Author: | It's About Time [ Fri Jun 07, 2013 6:51 am ] |
| Post subject: | New Magma Kettle Grill Mounting Question |
Hey everybody! I will soon be the proud owner of a new Magma kettle grill (West Marine is having a sale btw where you get a free cover) and I opted for the flush mount with the rain cap. Can anyone give any insight on installation? I have a 268 Vista and was thinking of putting it on the Port side just ahead of the fresh water cap. Is there anything I should be aware of or any hints that may be out there. I am just a bit nervous drilling a 1" hole in the fiberglass (luckily its above the waterline! -ha). Thanks for any input. |
|
| Author: | Paul I. [ Fri Jun 07, 2013 9:39 am ] |
| Post subject: | Re: New Magma Kettle Grill Mounting Question |
Just make sure the there is nothing below that you can hit. Use a sealer and mount it on the opposite side if the gas fill. Run the drill in reverse for 2 or 3 sec. so you don't put cracks into the gel coat. I don't store the LP on the boat, I leave them in my dock box until needed. LP is heaver than air and if it leaks, it could go into the engine compartment. BOOM! |
|
| Author: | ric [ Fri Jun 07, 2013 10:24 am ] |
| Post subject: | Re: New Magma Kettle Grill Mounting Question |
I installed that mount on my h180. I think its in the h180 mods Link |
|
| Author: | Rick2752 [ Fri Jun 07, 2013 12:10 pm ] |
| Post subject: | Re: New Magma Kettle Grill Mounting Question |
I have an angled rod holder on the port side above the cooler, and the magma mount slides into it. Works well the one time I used it ...lol |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|