I already have 2 pairs on my boat but I want to install another pair between the 2 side each side. Please email me at pchen621@yahoo.com if you have a pair for sale.
| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Looking for pair of factory 6" stainless non-pull up cleats https://www.smwebhead.com/phpBB3/viewtopic.php?f=22&t=7937 |
Page 1 of 1 |
| Author: | dopeeboy [ Mon Jul 04, 2011 11:29 pm ] |
| Post subject: | Looking for pair of factory 6" stainless non-pull up cleats |
I already have 2 pairs on my boat but I want to install another pair between the 2 side each side. Please email me at pchen621@yahoo.com if you have a pair for sale.
|
|
| Author: | wkearney99 [ Tue Jul 05, 2011 8:10 pm ] |
| Post subject: | Re: Looking for pair of factory 6" stainless non-pull up cleats |
Make sure the surfaced underneath where you're going to install them is strong enough to spread the load. There's usually a backing panel or significantly beefed up fiberglass behind a cleat. You should not just drill two holes and bolt it into place without something to spread the stress. Otherwise someone at a later date might assume it's a properly install cleat but then become seriously injured when it gets yanked out under stress. |
|
| Author: | dopeeboy [ Tue Jul 05, 2011 9:54 pm ] |
| Post subject: | Re: Looking for pair of factory 6" stainless non-pull up cleats |
Good point! Will make a note. |
|
| Author: | Jafo4U [ Wed Jul 06, 2011 2:56 am ] |
| Post subject: | Re: Looking for pair of factory 6" stainless non-pull up cleats |
Awesome point had no idea! I was actually thinking of doing the same to my boat. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|