www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
Trim not working (2008 H210; VP 5.0gxi) https://www.smwebhead.com/phpBB3/viewtopic.php?f=3&t=15600 |
Page 1 of 1 |
Author: | KNEEOIL [ Fri Jul 14, 2017 10:45 am ] |
Post subject: | Trim not working (2008 H210; VP 5.0gxi) |
Trim inoperable at launch yesterday (trimmed fully up). Relays both click, 10amp fuse fine, batteries new & fully charged, no corrosion on any wiring, trim switch unit fine. I checked the trim pump (on right side of lower unit) but no fuse there to check. Trim pump dead or anything else I can check before towing to shop? |
Author: | noexcuses [ Fri Jul 14, 2017 1:14 pm ] |
Post subject: | Re: Trim not working (2008 H210; VP 5.0gxi) |
Happened to me last year, with twin engines I was able swap power and determined that there was no power. There should be a red button on the back of the engine that resets the circuit. I think this occurred because I let my five year old trim the drives and didn't let up when outdrive was at max height. I can't find a decent picture of the button anywhere but you can see wiring harness diagram. http://www.volvopentastore.com/Engine-H ... _id.787168 |
Author: | KNEEOIL [ Fri Jul 14, 2017 2:12 pm ] |
Post subject: | Re: Trim not working (2008 H210; VP 5.0gxi) |
I think they changed the trim module at some point; we have the 5.0gxi-j. I dug around the back of engine and didn't find any kind of reset switch. I checked out the wiring diagram for our specific boat and also didn't see reference to a reset. Called the mechanic and he said it's a poor design; he sees these frequently and carries the pump replacement kit in stock. |
Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |