www.iFourWinns.com

The last time I used my boat was over Labor Day weekend. I recently charged the batteries and went to start the motor, but the trim-tilt motor will not work. I checked the tilt switch on the control and it has continuity, but no voltage. There is no noise at the pump, when the switch is activated. I also, removed the relays and cleaned the contacts. The same for the quick disconnect for the pump motor. I was told by my service center, there are two fuses, a 10 amp and a 50 amp fuse. I was able to find the 10 amp fuse and it was ok, but I can't locate the 50 amp fuse. It should be located somewhere around the pump, but I can't locate it.

Does anyone know the location on the 50 amp spade fuse on a 2005 FunShip 214, powered by a Volvo Penta 5.0 GXi-E motor?

The fuse panel under the dash, does not have any 50 amp fuses in it and there is no fuse socket labeled for the tilt/trim system.

Thanks,

There is most likely a red breaker button under your engine hatch...on my 2008 5.0GXi, its on the starboard sight of the boat above the valve cover mounted to a bracket. Try resetting that.

_________________
Current Boat:
2004 Sea Ray 320 Sundancer "Nauti Luvin'"

Previous Boats:
1999 298 Vista "Seas The Day"
2008 H200SS "Nauti Luv"
2006 Tahoe Q4

Bobfacs - What did you figure out on this?

Thx.

Erik

_________________
2002 Funship 214
VP 5.7 GX Si
2003 Tahoe