| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Engine Alignment tool https://www.smwebhead.com/phpBB3/viewtopic.php?f=11&t=1113 |
Page 1 of 1 |
| Author: | Graham R [ Tue Jul 17, 2007 3:43 pm ] |
| Post subject: | Engine Alignment tool |
Anyone know what makes these tools so special? I used to work a lot on manual shift equipped cars. I had an universal clutch alignment tool kit , but on the odd occasion it was not available ( usually when my brother living 100 miles away had it!), I found it just as effective to use a round section bar, with the diameter adjusted to the input shaft pilot bearing and spline diameters using insulating tape wrapped around the bar. Can't the same be done, with a bar adjusted the same way to the outdrive input shaft dimensions? regards, Graham |
|
| Author: | 230 Mike [ Tue Jul 17, 2007 4:58 pm ] |
| Post subject: | |
I've always wondered the same thing. The only thing I can think of is that they want the diameter of the thing to be *precisely* right. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|