| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Lower unit trim fill question https://www.smwebhead.com/phpBB3/viewtopic.php?f=11&t=13846 |
Page 1 of 1 |
| Author: | Flyer51 [ Sun Mar 15, 2015 3:52 pm ] |
| Post subject: | Lower unit trim fill question |
I was able to rebuilt my lift arms over the winter and so far all seems good however I cannot find instructions on exactly how full the trim reservoir should be. Do I trim the unit all the way up and then fill to the top of this access as shown in the photo. Also I still seem to have some air in the system after raising and lowering several times. Perhaps I just need to keep at it but would appreciate it if someone knows exactly the procedure to fill and bleed the system. 
|
|
| Author: | Thalasso [ Sun Mar 15, 2015 5:32 pm ] |
| Post subject: | Re: Lower unit trim fill question |
Trim down and fill. To remove air from hydraulic system, cycle trim/tilt system a minimum of five times, adding fluid. Remember new o-ring Page 256 http://boatinfo.no/lib/volvo/manuals/sx_dp-s_drive.html |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|