www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
Replacing aluminum prop with stainless . https://www.smwebhead.com/phpBB3/viewtopic.php?f=11&t=14362 |
Page 1 of 1 |
Author: | powermaker [ Thu Aug 06, 2015 9:11 pm ] |
Post subject: | Replacing aluminum prop with stainless . |
Do I go with the same dimensions ? My aluminum prop is 15x19 and seemed to do fine but I bent a blade . Dude on Craigslist has a stainless for $150 that will fit but it is 14x19 . I gotta admit it's hard to know if I should stick with a 3 blade aluminum , a four blade aluminum , or a stainless . It seems there's no definitive answer . Any help is appreciated . |
Author: | GottWhat [ Thu Aug 06, 2015 9:22 pm ] |
Post subject: | Re: Replacing aluminum prop with stainless . |
How did your last prop perform? Were you hitting the maximum recommended RPM range at WOT? If so, going from a 15x19 AL to the 14x19 SS prop will slightly increase the RPM. Going down in diameter increases the RPM but going from AL to SS typically decreases RPM slightly. |
Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |