I don't think so. I do not remember seeing anything like that. Do you see it below?
| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Volvo DP Annodes https://www.smwebhead.com/phpBB3/viewtopic.php?f=11&t=1594 |
Page 1 of 1 |
| Author: | St. Louis Dave [ Mon Mar 03, 2008 5:39 pm ] |
| Post subject: | Volvo DP Annodes |
New to me boat so before I put it in the water this spring, I want to make sure I have good annodes on my DP. How many are there and where are they? Pix would be great! |
|
| Author: | 230 Mike [ Mon Mar 03, 2008 7:32 pm ] |
| Post subject: | Re: Volvo DP Annodes |
There are two - one on the drive itself near the cavitation plate, and the other on the bottom of the transom shield. I don't have any pics, but I can try to take some if it would help. Presumably you've seen the other recent thread(s) on anodes? |
|
| Author: | St. Louis Dave [ Mon Mar 03, 2008 9:38 pm ] |
| Post subject: | Re: Volvo DP Annodes |
Yep. Search was my friend on this topic. I guess I am looking for specific pictures. Isn't there an annode on the prop too? |
|
| Author: | 230 Mike [ Mon Mar 03, 2008 11:31 pm ] |
| Post subject: | Re: Volvo DP Annodes |
Not on a DP. I see some pics I could link to online, but they're all from the wrong angle and they still don't show you where they're located. I'll try to get some pics in the next day or two. I'm curious - do you have the ACPS option on your boat? It would look like a small panel with some LED's on it, mounted somewhere in the engine bay (probably on the transom). I'm not sure if it even existed in '01, I'm just curious whether you have it. |
|
| Author: | St. Louis Dave [ Tue Mar 04, 2008 5:57 pm ] |
| Post subject: | Re: Volvo DP Annodes |
I don't think so. I do not remember seeing anything like that. Do you see it below?
|
|
| Author: | Graham R [ Wed Mar 05, 2008 7:43 am ] |
| Post subject: | Re: Volvo DP Annodes |
Dave, The VP shop manual for the 1999/ WT model year drives shows the 7.4 and 8.2 engines as having the ACPS system fitted, with a different transom shield to that of the smaller engines, I don't know about earlier ones. It's unlikely they would discontinue it, so as your boat dates from later than 1999, it probably has it, or at least had it originally. I don't see the controller in the engine compartment in your pic, might just be hidden away somewhere. Earlier control units look like the one in 230 Mikes photos on another thread, but only had one LED. The cable enters the transom shield on the port side, at the same height that the trim sender cable enters on the starboard. It might be easier just to check the outdrive; if fitted, from 1999 the reference and active electrodes are in a one piece plastic moulding mounted on the bottom transom shield, on the lower support arm ( along with the 2 ribbed anodes, inboard of the electrodes). If the anodes and/ or the electrodes are missing, this transom shield can be identified by the fact it has 5 bolt heads visible on the lower support, not 3, plus 4 tapped holes. This shield/ electrode pack were still in use until at least late 2003/ 2004: I have them on my 2004 boat ( built very late 2003). Regards, Graham |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|