| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Water Pressure Sensor Failure? https://www.smwebhead.com/phpBB3/viewtopic.php?f=11&t=15958 |
Page 1 of 1 |
| Author: | jtkey [ Thu May 31, 2018 11:31 am ] |
| Post subject: | Water Pressure Sensor Failure? |
2008 318, Merc 350 Mag MPI Last year I got the three beeps on the port engine. Tech found a bad water pressure sensor which was clogged with mud. Not having one on hand, he swapped it with a used one in his shop, cleared the fault and sent me on my way. Everything has been fine since. Until, I just installed VesselView and can actually see all the readings. The intake pressure on the port engine is 4psi at idle, 6psi at speed. The stbd is in the 40-50psi range. Still, no alarm and both engines run at perfect temperature. Any ideas what's going on here? I know it's worthwhile to change the port sensor for a new one, but if the pressure is so low, why would I not get an alarm or not be overheating? |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|