| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| 268 Vista Trim Sender (5.7 GSi DP) https://www.smwebhead.com/phpBB3/viewtopic.php?f=11&t=23378 |
Page 1 of 1 |
| Author: | YYZ-RC [ Sat Jun 01, 2019 10:44 am ] |
| Post subject: | 268 Vista Trim Sender (5.7 GSi DP) |
Is it spring yet? I replaced the trim sender before splashing and no response from the gauge. Hoping I didn't get a bad sender, but before I get angry over that possibility, is there a fuse somewhere? Wiring diagram doesn't show the engine harness so all I can find to go by is the purple/white wire at the gauge. Thank you. |
|
| Author: | Thalasso [ Sat Jun 01, 2019 6:28 pm ] |
| Post subject: | Re: 268 Vista Trim Sender |
Year/what drive? |
|
| Author: | Surface Interval [ Sat Jun 01, 2019 6:56 pm ] |
| Post subject: | Re: 268 Vista Trim Sender |
The sensor is the most likely source of trouble. Did you go through the adjustment process when you installed the trim sensor? If not, it is possible that the sensor is just way out of adjustment rather than faulty. |
|
| Author: | YYZ-RC [ Sun Jun 02, 2019 1:01 pm ] |
| Post subject: | Re: 268 Vista Trim Sender |
I fiddled with it a ton before launch and ultimately didn't have time to get it working/registering on the gauge at all. Any way to determine if the gauge is faulty? |
|
| Author: | Surface Interval [ Sun Jun 02, 2019 5:18 pm ] |
| Post subject: | Re: 268 Vista Trim Sender (5.7 GSi DP) |
Try Googling "troubleshooting Faria trim gauges". Just a thought. |
|
| Author: | Graham R [ Mon Jun 03, 2019 3:48 pm ] |
| Post subject: | Re: 268 Vista Trim Sender (5.7 GSi DP) |
Surface Interval wrote: Try Googling "troubleshooting Faria trim gauges". Just a thought. The sender needed to be adjusted to 11 +/- 1 ohms with the drive down if I remember correctly. |
|
| Author: | derekd [ Sat Jul 06, 2019 9:39 am ] |
| Post subject: | Re: 268 Vista Trim Sender (5.7 GSi DP) |
I just put new sender on mine in the spring. I found a bad connection at the main engine cannon plug not allowing signal to dash gauge , maybe look there. If I remember the wire from sender was brown then after the plug it was the purple white. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|