www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
gimble bearing and seal https://www.smwebhead.com/phpBB3/viewtopic.php?f=11&t=23485 |
Page 1 of 1 |
Author: | byron [ Tue Nov 26, 2019 2:26 pm ] |
Post subject: | gimble bearing and seal |
I have a DPS-B drive and am in the process of replacing the gimble bearing. I have the old bearing out and ready to install the new one. However I have two questions. 1. The Volvo shop manual says on page 220 "Position the gimbal bearing with the ring slots facing in towards shield. When I removed the old bearing the slots were facing out. Which is the right way. 2. I would like to replace the gimble bearing seal at this time. If so how does the old one get removed. How does the new one go in, do I need the "special tool". 3850038? |
Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |