| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Gimble Bearing https://www.smwebhead.com/phpBB3/viewtopic.php?f=11&t=5852 |
Page 1 of 1 |
| Author: | dgs119 [ Fri Jun 11, 2010 6:18 pm ] |
| Post subject: | Gimble Bearing |
Is there a zirc that I can grease the gimble bearings without having to pull the outdrive? If so where is it located and what type of grease would I use. I have a H190 with a Volvo SX outdtrive. Thanks |
|
| Author: | 230 Mike [ Fri Jun 11, 2010 9:33 pm ] |
| Post subject: | Re: Gimble Bearing |
Right-hand side of the transom shield, right up against the transom. The zirk is in a recess. On a 190 it might be hard to get to, I think someone recently said they had to buy a right-angle adapter for their grease gun. It should be greased with the engine running, and as soon as resistance is felt, stop. |
|
| Author: | Burdette [ Sat Jun 12, 2010 7:29 am ] |
| Post subject: | Re: Gimble Bearing |
I dont think a 2007 has a grease fitting.I believe it is a sealed bearing. Andrew |
|
| Author: | 230 Mike [ Sat Jun 12, 2010 1:19 pm ] |
| Post subject: | Re: Gimble Bearing |
The new ones can't be greased? Interesting, I didn't know that. |
|
| Author: | Aussie_Horizon_190 [ Mon Jun 14, 2010 6:49 pm ] |
| Post subject: | Re: Gimble Bearing |
Mine has a zerk exactly as Mike described it. I got a small flexible hose for my grease gun to get to it. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|