www.iFourWinns.com

Dedicated to Current and Future Owners
It is currently Fri May 02, 2025 4:55 pm

View unanswered posts | View active topics


Board index » Care and feeding » Engine, Drive, Prop

All times are UTC - 6 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
Desert Steve
 Post subject: O/D torque sequence
PostPosted: Sat Jun 12, 2010 11:56 pm 
Offline
Starfish

Joined: Thu Jul 06, 2006 12:39 pm
Posts: 51
Location: Pendleton, OR
I have a 98 FW 258 with a duoprop O/D and I removed the O/D unit to grease the universal joint. It is time to torque the 6 nuts that hold the unit and I cannot find my manual that has the sequence in which to torque the nuts. My memory is right center, left center, right top, left top, right bottom, left bottom, but I am not sure. Any help on the correct sequence is appreciated.

Thanks,
Top
 Profile  
 
Desert Steve
 Post subject: Re: O/D torque sequence
PostPosted: Sun Jun 13, 2010 12:07 am 
Offline
Starfish

Joined: Thu Jul 06, 2006 12:39 pm
Posts: 51
Location: Pendleton, OR
I just found the manual - I was close but the correct sequence is center right, center left, upper right, lower left, lower right, and then upper left.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Care and feeding » Engine, Drive, Prop

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 13 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group