Anyone have experience replacing the plastic PITOT that reads speed. This bad boy (image) caught a piece of wood and chipped off the bottom part. Can I just unscrew the old one and attach a new one? Any special trick to it?
Thanks!
| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Speedo PITOT busted. Replace? https://www.smwebhead.com/phpBB3/viewtopic.php?f=11&t=9637 |
Page 1 of 1 |
| Author: | mark1190 [ Fri Jun 22, 2012 10:23 pm ] |
| Post subject: | Speedo PITOT busted. Replace? |
Anyone have experience replacing the plastic PITOT that reads speed. This bad boy (image) caught a piece of wood and chipped off the bottom part. Can I just unscrew the old one and attach a new one? Any special trick to it? Thanks!
|
|
| Author: | fiznuka [ Fri Jun 22, 2012 10:44 pm ] |
| Post subject: | Re: Speedo PITOT busted. Replace? |
Yes just remove the screws and the hose and install the new one. Use some sealant (3M 4200-5200)on the screws when reinstalling. Piece of cake. |
|
| Author: | 204Angler [ Sat Jun 23, 2012 11:20 am ] |
| Post subject: | Re: Speedo PITOT busted. Replace? |
I would just use 5200 |
|
| Author: | ric [ Sat Jun 23, 2012 12:48 pm ] |
| Post subject: | Re: Speedo PITOT busted. Replace? |
the trick is to not drop the screws in the water |
|
| Author: | mark1190 [ Sun Jun 24, 2012 11:53 am ] |
| Post subject: | Re: Speedo PITOT busted. Replace? |
Trying to get Pitot tube off. The screw come out easy, but the base appears to be GLUED on. Is that just the sealant? Should I stick a screwdriver under there and pry it off? |
|
| Author: | EvilZ [ Sun Jun 24, 2012 12:18 pm ] |
| Post subject: | Re: Speedo PITOT busted. Replace? |
Probably just the sealant. Be careful prying with a screwdriver - you dont want to damage the gelcoat.... |
|
| Author: | mark1190 [ Sun Jun 24, 2012 9:41 pm ] |
| Post subject: | Re: Speedo PITOT busted. Replace? |
Thanks for all the advice. For anyone looking at this thread in the future I purchased the pitot tube at West Marine (about 12 bucks) and after I removed the screws on the old pitot I used a wide chisel to tap at the corner of the pitot to help remove it. It got under the sealant and plastic very easily, and once under it popped right off without scratching the gel coat. I cleaned the area to pristine condition (the whitest part of the stern now) and placed the new pitot tube on the stern using lots of sealant. Everything looks perfect and I can't wait to get the Sundowner 205 on the water for a test drive. For the record, I use GPS now when I am underway. And it gives me a much clearer idea of speed, etc. But there's something about having all the gauges work, right? Mark |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|