| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| U-joint Bellows clamp position https://www.smwebhead.com/phpBB3/viewtopic.php?f=11&t=9708 |
Page 1 of 1 |
| Author: | neutron [ Sun Jul 01, 2012 3:40 pm ] |
| Post subject: | U-joint Bellows clamp position |
for the second time in my boating life I have a had new bellows rip due to the clamp position. I put the clamp in the 2 o-clock position with the ajusting screw pointing to 1 o-clock. what am I doing wrong I used a FW boot kit and I went by the picture. any advice. now I am going to replaced the boot as well as the gimble bearing to be safe and this happened today and when I got home and saw the rip I cut the bottem of the boot to drain the rest of the salt water out, and then jammed the garden hos into the hole and flushed fresh water through it for a while. Tomorrow I will remove the drive... Should the u-joints be ok? they are the non-greasable joints. |
|
| Author: | Borchik [ Mon Jul 02, 2012 1:01 pm ] |
| Post subject: | Re: U-joint Bellows clamp position |
Almost positive the screw should be on top with the head facing the port side of the boat. |
|
| Author: | neutron [ Mon Jul 02, 2012 2:29 pm ] |
| Post subject: | Re: U-joint Bellows clamp position |
well my FW manual says either 1 or 2 o-clock position and it shows the adjuster screw looking at 3 o-clock. The meatballs at FW said thats what it should be(not that i trust them, they sell parts and are not great at advice or diag) so thats what i ended up doing this morning. new gimble bearing and boot. all together ready for the water for tomorrow night. |
|
| Author: | Graham R [ Tue Jul 03, 2012 3:57 am ] |
| Post subject: | Re: U-joint Bellows clamp position |
The VP manual I have spexcified the clamp should be in the one or two-o-clock position, but doesn't indicate in writing where the screw head should be. However, in the photos in the manual, on close examination the screw head is facing down, I have always aligned the clamp that way on my bellows since 2002; never had one tear. |
|
| Author: | neutron [ Tue Jul 03, 2012 6:43 am ] |
| Post subject: | Re: U-joint Bellows clamp position |
Graham R wrote: The VP manual I have spexcified the clamp should be in the one or two-o-clock position, but doesn't indicate in writing where the screw head should be. However, in the photos in the manual, on close examination the screw head is facing down, I have always aligned the clamp that way on my bellows since 2002; never had one tear. well last night after work and a lot of inspecting of the old clamp i decided to use the clamp that was on a few months ago with the original boot. the edges of the clam that comes with the FW boot kit have extremly sharp edges, so I just removed the clamp and slid this one that is a different brand in place. it has all smooth sides and i figure it was in there for a few years with no tears. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|