www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
Trailer tire clearance https://www.smwebhead.com/phpBB3/viewtopic.php?f=12&t=11561 |
Page 1 of 1 |
Author: | Water Boy 1950 [ Wed May 22, 2013 1:46 pm ] |
Post subject: | Trailer tire clearance |
Hey guys, just picked up a new aluminum bunk trailer for my 241 Libby. How much clearance should there be between the top of the tires and the bottom of the fender with the boat loaded? |
Author: | neutron [ Wed May 22, 2013 7:36 pm ] |
Post subject: | Re: Trailer tire clearance |
Is it squatting a lot? I have about 4 of my fat fingers between the fender and the tire, and its loaded completly loaded. Fuel, water, gear, etc... |
Author: | Water Boy 1950 [ Thu May 23, 2013 7:40 pm ] |
Post subject: | Re: Trailer tire clearance |
Hi Neutron, only two of my fat fingers between my tire and fender. |
Author: | neutron [ Thu May 23, 2013 9:29 pm ] |
Post subject: | Re: Trailer tire clearance |
That seems a bit tight. Whats the gvw of the trailer. Mine Is 6500lbs but the axles have bern replaced with heavier axles. Springs are stock |
Author: | Water Boy 1950 [ Thu May 23, 2013 9:39 pm ] |
Post subject: | Re: Trailer tire clearance |
Ha! Just made a discovery...my trailer has the same GVW and is listed for a 23-24ft. Boat. Mine is 23' 8" The discovery is that the fenders are made with 2 sets of mounting holes and the second set is lower and plastic plugged. All I have to do now is remount to the second position which will raise the fenders by 2". Should now avert any clearance problems! |
Author: | neutron [ Fri May 24, 2013 6:17 am ] |
Post subject: | Re: Trailer tire clearance |
Thats good news |
Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |