www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
Bearing, racer and seal size https://www.smwebhead.com/phpBB3/viewtopic.php?f=12&t=15577 |
Page 1 of 1 |
Author: | 1baddoggy [ Thu Jul 06, 2017 5:41 pm ] |
Post subject: | Bearing, racer and seal size |
I have a 2007 Horizon 210 with the factory trailer. It's equipped with electric drum brakes. I'm getting ready to take a long trip and, as the new owner, have no idea the last time the bearings were done. For peace of mind, I'd like to just replace the bearings, racers and seals. Can anyone tell me how to figure out what sizes I need? Thanks! |
Author: | Thalasso [ Thu Jul 06, 2017 6:43 pm ] |
Post subject: | Re: Bearing, racer and seal size |
The bearings you take out should have a number on them |
Author: | 230 Mike [ Thu Jul 06, 2017 10:56 pm ] |
Post subject: | Re: Bearing, racer and seal size |
+1. Take one hub off, and pull the grease seal out of the back side. Now you'll have both the inner & outer bearing which will have numbers etched into them. Youll have to drive the races out. They aren't marked but whoever you buy the bearings from can match them. You'll also need new double-lipped spring reinforced seals. |
Author: | 1baddoggy [ Fri Jul 07, 2017 8:19 am ] |
Post subject: | Re: Bearing, racer and seal size |
Thanks guys! |
Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |