www.iFourWinns.com https://www.smwebhead.com/phpBB3/
Trailer bearing size? https://www.smwebhead.com/phpBB3/viewtopic.php?f=12&t=41	Page 1 of 1

---

Author:	njlarry609 [ Fri May 26, 2006 10:09 am ]
Post subject:	Trailer bearing size?
Does anyone know the correct size bearings for a 1996 20' Horizon Four Winns trailer? Single axle, drum brakes. Thank you for your help.

---

Author:	ifourwinns [ Fri May 26, 2006 10:50 am ]
Post subject:
005-0440 BEARING INNER #2600 (TIMKIN 25580) 005-0441 BEARING OUTER #2600 HUB (TIMKIN 15123)

---

Author:	njlarry609 [ Fri May 26, 2006 11:04 am ]
Post subject:
Many thanks! I have 300 mile+ drive to bring back my "new" four winns and wanted to have some spare parts. I assume that with the timkin bearing numbers the local West marine will find the seals too. Never towed anything this big with my Explore before so want to be prepared.

---

Author:	ifourwinns [ Fri May 26, 2006 11:08 am ]
Post subject:
you can find all the part numbers... click on "parts catalog" on the homepage. http://www.ifourwinns.com

---

Author:	njlarry609 [ Fri May 26, 2006 1:25 pm ]
Post subject:
Thanks. This site is very helpful to newbie. Unfortunately West sells its bearings by size and has no cross reference to timkin. Is 1 3/8-1 1/16 tapered the right size?

---

Author:	230 Mike [ Fri May 26, 2006 6:24 pm ]
Post subject:
The Timken numbers aren't unique. I replaced all the bearings on my trailer last fall. All I had were the Timken numbers from Four Winns. I went into my local trailer shop where they sell Chinese-made bearings. All the part numbers were the same as Timkens. So if you know you need a 25580, you should be able to get a "25580" anyplace that sells bearings. If West can't tell you the bearing number, personally I'd go elsewhere rather than get tied up trying to do it by dimensions.

---

Page 1 of 1	All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/