www.iFourWinns.com
https://www.smwebhead.com/phpBB3/

Wheel bearing grease ????
https://www.smwebhead.com/phpBB3/viewtopic.php?f=12&t=5825
Page 1 of 1

Author:  millhaven_nice_guy [ Tue Jun 08, 2010 7:21 pm ]
Post subject:  Wheel bearing grease ????

I'm in the process of preparing to re-pack the bearings on my trailer.... I'm planning on using some standard wheel bearing grease.
Question is .........
Should I buy another grease gun and pack it with this same grease so that I don't cross contaminate the grease if I use my standard gun?
Can I use standard Heavy duty service grease for this application?

Author:  Burdette [ Tue Jun 08, 2010 7:48 pm ]
Post subject:  Re: Wheel bearing grease ????

I use marine/waterproof (more expensive of course) grease. I also have a separate grease gun just for the boat trailers.
Andrew

Author:  230 Mike [ Tue Jun 08, 2010 7:59 pm ]
Post subject:  Re: Wheel bearing grease ????

I standardized on Mobil 1 Synthetic partially so I could use one gun for everything. If I was going to use a standard wheel bearing grease for boat trailer hubs I'd use a marine grease, available at WalMart, and I'd put it in a separate gun just to be safe.

Author:  Aussie_Horizon_190 [ Tue Jun 08, 2010 10:41 pm ]
Post subject:  Re: Wheel bearing grease ????

+1 with Andrew. Definately go with marine grease for your wheel bearings. I have a dedicated grease gun for doing this.

Author:  millhaven_nice_guy [ Wed Jun 09, 2010 12:01 pm ]
Post subject:  Re: Wheel bearing grease ????

Thanks guys. I will do some digging on what is easily available here and either make a change or buy another grease gun.

Author:  Aquadisiac [ Wed Jun 09, 2010 6:53 pm ]
Post subject:  Re: Wheel bearing grease ????

Burdette wrote:
I use marine/waterproof (more expensive of course) grease. I also have a separate grease gun just for the boat trailers.
Andrew

I believe all grease is waterproof

Author:  LouC [ Wed Jun 09, 2010 9:07 pm ]
Post subject:  Re: Wheel bearing grease ????

I use the Pennzoil Marine grease for everything...the trailer wheel bearings...gimble bearing...and the front end grease fittings (there are 7 of em!) on my old 98 Jeep...

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/