Don't like the idea of sanding in there
Will the coating not stick to the original surface once cleaned?
| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Ski locker needs attention https://www.smwebhead.com/phpBB3/viewtopic.php?f=14&t=11596 |
Page 1 of 1 |
| Author: | atbspinner [ Fri May 24, 2013 4:32 pm ] |
| Post subject: | Ski locker needs attention |
Thinking about recoating the inside of the ski locker. I have some old coating chipping off and don't want any water damage in there. Any suggestions for what would work best? Thanks! |
|
| Author: | deafwish [ Fri May 24, 2013 5:51 pm ] |
| Post subject: | Re: Ski locker needs attention |
Sand back the entire area and roll on a coat of 'Flowcoat'. Once painted, consider putting a rubber mat on the locker's floor, to protect the flowcoat. |
|
| Author: | atbspinner [ Sat May 25, 2013 10:18 pm ] |
| Post subject: | Re: Ski locker needs attention |
Don't like the idea of sanding in there Will the coating not stick to the original surface once cleaned? |
|
| Author: | deafwish [ Sun May 26, 2013 2:47 am ] |
| Post subject: | Re: Ski locker needs attention |
atbspinner wrote: Don't like the idea of sanding in there Will the coating not stick to the original surface once cleaned? If the existing gelcoat is chipping, you'll have to sand it. Like painting a door, it's always a good idea to give it a sand prior to painting... |
|
| Author: | LouC [ Sun May 26, 2013 9:51 am ] |
| Post subject: | Re: Ski locker needs attention |
If you want anything to stick to it you have to sand. If its gel coated inside then I'd stick with that, just re-gelcoat it. Sand first wipe down with solvent let dry and re-gelcoat. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|