I have a Taylor mooring ball that has 2 prop cuts on itthat are about 1/4 inch deep, and 3" long. What should I use to patch
the gashes? I'm not sure if epoxy will stick to the surface, or perhaps
some sort of silicone sealer?? Thank you, John
| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Repair help needed https://www.smwebhead.com/phpBB3/viewtopic.php?f=14&t=13639 |
Page 1 of 1 |
| Author: | jrboater [ Wed Nov 26, 2014 12:03 pm ] |
| Post subject: | Repair help needed |
| I have a Taylor mooring ball that has 2 prop cuts on it that are about 1/4 inch deep, and 3" long. What should I use to patch the gashes? I'm not sure if epoxy will stick to the surface, or perhaps some sort of silicone sealer?? Thank you, John |
|
| Author: | Paul I. [ Wed Nov 26, 2014 12:48 pm ] |
| Post subject: | Re: Repair help needed |
5200 or 4000 sealant, quick dry. BUT, I called Taylor on this same problem on my mooring. They told me, it would not harm the mooring at all. |
|
| Author: | jrboater [ Mon Dec 01, 2014 11:46 am ] |
| Post subject: | Re: Repair help needed |
Thank you for the info. John |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|