www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
Anodes https://www.smwebhead.com/phpBB3/viewtopic.php?f=2&t=10985 |
Page 1 of 1 |
Author: | JeffLW [ Tue Feb 19, 2013 4:40 pm ] |
Post subject: | Anodes |
For a Mercruiser Bravo III. MARTYR or Quicksilver, what is the difference? Does Mercury even sell replacement anode kits? All I seem to find online are these two brands. Found a good deal on a Quicksilver kit and was wondering what everyone is using before I purchase. |
Author: | RotaryRacer [ Tue Feb 19, 2013 4:46 pm ] |
Post subject: | Re: Anodes |
Quicksilver is Mercury. Thats their aftermarket/parts side. |
Author: | Alan_G_298Vista [ Tue Feb 19, 2013 4:51 pm ] |
Post subject: | Re: Anodes |
Don't forget, freshwater boating requires Magnesium anodes, zinc is for salt water use and they go for less than half the cost of the Magnesium anodes so these might be what your thinking are a very good deal! |
Author: | JeffLW [ Tue Feb 19, 2013 6:30 pm ] |
Post subject: | Re: Anodes |
Yes I'm looking at Magnesium. Best price I've seen so far: Here |
Author: | Cap'n Morgan [ Tue Feb 19, 2013 7:10 pm ] |
Post subject: | Re: Anodes |
Price is good, even for non-member. Add shipping too I suspect. I always bought mine here. http://www.boatzincs.com/bravo3-mag-kit.html Free shipping over $100, but the zincs are not quite that expensive. |
Author: | JeffLW [ Tue Feb 19, 2013 7:55 pm ] |
Post subject: | Re: Anodes |
Thanks. I'm already a member and I managed to get free shipping. ![]() Now on to the next item on the winter todo list. Think spring! ![]() |
Author: | ric [ Tue Feb 19, 2013 9:27 pm ] |
Post subject: | Re: Anodes |
I always buy mine off boatzincs |
Author: | deafwish [ Wed Feb 20, 2013 12:02 am ] |
Post subject: | Re: Anodes |
Is there an easy DIY test to see if a used boat has zinc or magnesium anodes? |
Author: | Morceri [ Wed Feb 20, 2013 4:28 am ] |
Post subject: | Re: Anodes |
RotaryRacer wrote: Quicksilver is Mercury. Thats their car accessories side. Hello from where I could purchase these aftermarket parts? Waiting for reply |
Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |