www.iFourWinns.com :: View topic

Yes, there are a lot of posts on here about the VDO instrument cluster. Both repair and replacement.

Yours looks like it is in nice condition...is it definitely bad? There is a known issue with the ground on these panels, that can be fixed by adding an additional ground to the circuit board. I have only had trouble with mine twice, and both times it was something else. 1st time was a symptom of a failed alternator. 2nd time was a bad fuse...turned out the fuse was not in the fuse block, but in-line fuse in the wire leading to the instrument cluster. So my VDO panel still works great.

There are some other posts that show a complete replacement with round instruments.
Use the search function using "VDO Instrument" because you cannot search just three letters.

Edit: I see you have used the search function, as you have posted your question in four different locations.

Author:	newbiechris [ Mon May 19, 2014 10:10 pm ]
Post subject:	Vdo help
Has anybody swapped this dash if so can post photos Thanks

Author:	rpengr [ Tue May 20, 2014 6:58 am ]
Post subject:	Re: Vdo to faria swap
Yes, there are a lot of posts on here about the VDO instrument cluster. Both repair and replacement. Yours looks like it is in nice condition...is it definitely bad? There is a known issue with the ground on these panels, that can be fixed by adding an additional ground to the circuit board. I have only had trouble with mine twice, and both times it was something else. 1st time was a symptom of a failed alternator. 2nd time was a bad fuse...turned out the fuse was not in the fuse block, but in-line fuse in the wire leading to the instrument cluster. So my VDO panel still works great. There are some other posts that show a complete replacement with round instruments. Use the search function using "VDO Instrument" because you cannot search just three letters. Edit: I see you have used the search function, as you have posted your question in four different locations.

Author:	newbiechris [ Tue May 20, 2014 7:47 am ]
Post subject:	Re: Vdo to faria swap
rpengr wrote: Yes, there are a lot of posts on here about the VDO instrument cluster. Both repair and replacement. Yours looks like it is in nice condition...is it definitely bad? There is a known issue with the ground on these panels, that can be fixed by adding an additional ground to the circuit board. I have only had trouble with mine twice, and both times it was something else. 1st time was a symptom of a failed alternator. 2nd time was a bad fuse...turned out the fuse was not in the fuse block, but in-line fuse in the wire leading to the instrument cluster. So my VDO panel still works great. There are some other posts that show a complete replacement with round instruments. Use the search function using "VDO Instrument" because you cannot search just three letters. Edit: I see you have used the search function, as you have posted your question in four different locations. I'm not 100% sure if this is a ground issue or not. My fuel gauge is all over the place, it will work fine for a little bit and then all if a sudden Feul light will kick on and alarm will start beeping for a while and then it will go back to normal or tell me I have a 1/4 tank when it's full. I also think my oil pressure gauge is a little high but only sometimes. I just bought the boat and have only been out on her twice both times after about ten minutes I'd start getting the feul issue. Boat had full inspection done at marina and checked out great

Author:	rpengr [ Tue May 20, 2014 8:31 am ]
Post subject:	Re: Vdo to faria swap
The Fuel gauge issue could easily be a bad sending unit, or bad connection at the sending unit. I would start by cleaning the connection of the ground and send wires at the fuel tank sending unit. Your Horizon probably has a round access cover over the back of the fuel tank (centerline of boat floor, just in front of the engine. This cover would be under the rear seats if you have sunsport seating. After cleaning these connections, coat them with a corrosion preventative such as BoeSheild T-9, or a light coat of grease (such as triple guard grease), If that doesn't work, I would change the sending unit, as they are only about a $30 item, and they are prone to have a limited life. In my experience, oil sending units are quite reliable. What do you mean by oil pressure "a little high but only sometimes"? Oil pressure will be highest with a cold engine and higher RPMs. Oil pressure will be lowest with a hot engine at idle. Ray

Author:	97_245_sd [ Tue May 20, 2014 11:31 am ]
Post subject:	Re: Vdo to faria swap
You mentioned you just bought the boat, I'm not sure if you're new to boating in general. In case you are new, don't expect the fuel gage to act like one in a car, it will move quite a bit as the boat goes over waves, also will change from being at rest to getting up on plane as the bow goes up in the air. Having said that, it shouldn't go from full to empty that quickly, just that it from my experience it might vary around a quarter of a tank from actual amount of fuel.

www.iFourWinns.com https://www.smwebhead.com/phpBB3/

Vdo help https://www.smwebhead.com/phpBB3/viewtopic.php?f=2&t=12908	Page 1 of 1

Author:	ric [ Tue May 20, 2014 5:40 pm ]
Post subject:	Re: Vdo to faria swap
I have a new sending unit and new ends on the wiring of my chap's fuel gauge, and it still only works half the time.

Author:	newbiechris [ Tue May 20, 2014 6:47 pm ]
Post subject:	Re: Vdo to faria swap
Don't really care if the fuel gauge is accurate or even works but the beeping alarm that comes on is very annoying and doesn't stop

Author:	acguy [ Tue May 20, 2014 8:13 pm ]
Post subject:	Re: Vdo to faria swap
It's been awhile since I had a dash like that but is the beeping from the depth alarm? You should be able to set the shallow and deep alarm points on it if so

Author:	newbiechris [ Tue May 20, 2014 9:34 pm ]
Post subject:	Re: Vdo to faria swap
acguy wrote: It's been awhile since I had a dash like that but is the beeping from the depth alarm? You should be able to set the shallow and deep alarm points on it if so No it's not the depth alarm I have turned it off and triple checked it. I'm going to try a new feul sending unit and see if that works. Everytime except for once when I disconnected battery for a few seconds and restarted it seemed to reset the gauge to normal

Author:	Technologic80 [ Fri May 23, 2014 9:05 am ]
Post subject:	Re: Vdo help
Ahhh yes... the VDO dash panel. We go back a long ways, a most unforgettable foe. Where do I begin.... Two boats ago, I had a 99 Vista 258 with that dash. The low fuel alarm would come on randomly and the gauge would sometimes drop to E, sometimes not. I replaced the sending unit. Finally, right before I got rid of the boat, more gauges would stop working at random and make that ANNOYING alarm go off non stop. The two buttons to control the little info display were just about useless. That cluster was a bad idea and VDO/Four Winns should be flogged for it. I had my marina add an (additional?) ground wire to the cluster, which was recommended by the forums at the time. No difference. Getting my present boat, a 97 Vista 278 with regular normal gauge cluster was the BEST thing I ever did.

Author:	SeriousRob [ Tue May 27, 2014 11:47 am ]
Post subject:	Re: Vdo help
Here is a link to the dash I made to replace the VDO viewtopic.php?f=2&t=9061

Author:	newbiechris [ Wed May 28, 2014 6:04 pm ]
Post subject:	Re: Vdo help
SeriousRob wrote: Here is a link to the dash I made to replace the VDO viewtopic.php?f=2&t=9061 I love the dash!! Maybe ill doth is at the end of season I just replaced the fuel sending unit but have yet to get out on the water to test if it fixed my fuel alarm issue . I know you changed the speedo but other then that was it only a matter of splicing the new gauges in under the dash or was more work required Thanks

Page 1 of 1	All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/