Yeah I've heard that same kind of talk about it being ok to leave WOT for long periods of time, but usually not from sources I would trust. I also test it once or twice a season for not more than about 30 seconds...then I feel guilty and back off
| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| WOT https://www.smwebhead.com/phpBB3/viewtopic.php?f=2&t=13672 |
Page 1 of 1 |
| Author: | fi.na.tine [ Sat Dec 20, 2014 3:09 am ] |
| Post subject: | WOT |
I have personal difficulties putting my boat into WOT. (As in not limited by mechanics) I have only run it there a very few times - thinking that not doing so will prolong the engine life. Is this correct thinking, or should I just go WOT whenever and not worry about it? |
|
| Author: | NiagaraChillin [ Sat Dec 20, 2014 9:47 am ] |
| Post subject: | Re: WOT |
Mechanically, it won't harm the engine to go WOT occasionally. Really depends on your boating style, my personal preference is to "cruise" at about 20-25 knots. A couple of times a summer I'll go WOT just to blow the dust out. |
|
| Author: | LouC [ Sat Dec 20, 2014 11:01 am ] |
| Post subject: | Re: WOT |
Volvo had said that an inboard will last longest if its most often run not more than 75% of wot which is about 3500 rpm. That said there's nothing wrong with doing it once in a while. Its important to know that your wot rpms are right. This is why outboards are considered higher performance. A 2 stroke outboard has no valve gear to wear out and as long as the fuel mix and oil injection is functioning properly going wot is fine. A 4 stroke outboard's valve gear is made for high rpms. My '89 Toyota Corolla GTS had the 1.6 twin cam engine. It produced max torque over 4,000 rpm and could be revved to 6,000 rpm regularly with out damage. The cyl head on these was designed by Yamaha for Toyota and guess how Yamaha 4 stroke outboards are set up? Basically the same way. Our old school inboards were not designed for this use hence the recommendation that you cruise at 3500. |
|
| Author: | Decision [ Sat Dec 20, 2014 11:10 am ] |
| Post subject: | Re: WOT |
I'll run our 328 up to WOT a couple times a year just to make sure I reach the manufactures specification for WOT RPM and the corresponding expected speed. My thoughts are if I can't reach the expected WOT RPM and speed then I should be finding out why. If you have an issue with maybe your prop being dinged or slightly bent, a issue with your fuel delivery or spark or some other engine mechanical issue the symptoms may not show up at cruise speed, but may show up in your inability to reach WOT. You don't have to mash the throttle(s) to the peg(s) just move your cruise speed up over 4000 RPM and then move to WOT for a very brief period of time. For me about one minute or less at WOT is all I need. Plus letting her rip is fun in moderation. My 2 cents anyways. |
|
| Author: | Bliss36 [ Sat Dec 20, 2014 11:19 am ] |
| Post subject: | Re: WOT |
Yeah I've heard that same kind of talk about it being ok to leave WOT for long periods of time, but usually not from sources I would trust. I also test it once or twice a season for not more than about 30 seconds...then I feel guilty and back off
|
|
| Author: | LVChris [ Sat Dec 20, 2014 6:37 pm ] |
| Post subject: | Re: WOT |
I did this for the first time a couple weeks ago.. I hit 42mph at 4400 rpm..of course that was the gauge on the dash...wish I would have gps' it. I typically cruise at 27mph at 3500. |
|
| Author: | Surface Interval [ Sat Dec 20, 2014 8:38 pm ] |
| Post subject: | Re: WOT |
You should have no trouble "airing it out" now and then for a short blast. It is a good way to verify the boat's performance. Keep in mind that prolonged running at high power settings can cause higher oil temps which causes to lower oil pressure. Prolonged use at full power would probably shorten engine life, but an occasional run shouldn't hurt anything. Pick a good time with relatively calm water. Things get really hairy with an unexpected wave or boat wake. I am always more concerned about traffic and water conditions for a short blast at top speed than engine harm. I used to do this on my '95 190 Horizon, and I put over 2000 hours on the boat. The boat still ran great when I sold it. Its a boat. Be safe and have fun with it. |
|
| Author: | pickledboater [ Sun Dec 21, 2014 3:47 pm ] |
| Post subject: | Re: WOT |
NiagaraChillin wrote: Mechanically, it won't harm the engine to go WOT occasionally. Really depends on your boating style, my personal preference is to "cruise" at about 20-25 knots. A couple of times a summer I'll go WOT just to blow the dust out. I'm on Niagara's team on this one. I usually try to run WOT for just a brief moment at the close of each outing, conditions permitting. It's my way to make sure I reach my top speed and it lets me know if all is well. |
|
| Author: | fi.na.tine [ Mon Dec 22, 2014 12:40 am ] |
| Post subject: | Re: WOT |
Thanks - I know of people who run WOT all day every day - and most of those people's boats have had issues - so it goes to figure this was the problem. I'll still bump her into WOT on occasion, but maintain my 3500 for the most part. |
|
| Author: | TX H210SS [ Mon Dec 22, 2014 11:22 pm ] |
| Post subject: | Re: WOT |
Point has been made already, but me too. I will open it up every now and then but usually back off before it tops out speed wise. Its really way faster than I care to go. I usually run around 35 or so if water conditions are good. |
|
| Author: | Paul I. [ Tue Dec 23, 2014 12:06 pm ] |
| Post subject: | Re: WOT |
LVChris wrote: I did this for the first time a couple weeks ago.. I hit 42mph at 4400 rpm..of course that was the gauge on the dash...wish I would have gps' it. I typically cruise at 27mph at 3500. Off topic, SORRY!! I just noticed, you bow line runs up to your bow railing. Why not use the bow cleat? |
|
| Author: | Jdpber [ Sat Dec 27, 2014 5:17 pm ] |
| Post subject: | Re: WOT |
NiagaraChillin wrote: Mechanically, it won't harm the engine to go WOT occasionally. Really depends on your boating style, my personal preference is to "cruise" at about 20-25 knots. A couple of times a summer I'll go WOT just to blow the dust out. This, music rocking, beverage in hand. Conversation, looking at the multi million dollar houses, loving life |
|
| Author: | LVChris [ Sun Dec 28, 2014 3:19 am ] |
| Post subject: | Re: WOT |
Paul I. wrote: LVChris wrote: I did this for the first time a couple weeks ago.. I hit 42mph at 4400 rpm..of course that was the gauge on the dash...wish I would have gps' it. I typically cruise at 27mph at 3500. Off topic, SORRY!! I just noticed, you bow line runs up to your bow railing. Why not use the bow cleat? Interesting question...there is no way to reach that cleat from the dock. Since I handle her a lot by myself I need an easy way to tie and un-tie her. The rear cleat is no problem, the center cleat is un-reachable from inside and the front cleat is unreachable from the dock. So necessity turned to tying off to the bow rail. |
|
| Author: | Jdpber [ Sun Dec 28, 2014 7:55 am ] |
| Post subject: | Re: WOT |
LVChris wrote: Paul I. wrote: LVChris wrote: I did this for the first time a couple weeks ago.. I hit 42mph at 4400 rpm..of course that was the gauge on the dash...wish I would have gps' it. I typically cruise at 27mph at 3500. Off topic, SORRY!! I just noticed, you bow line runs up to your bow railing. Why not use the bow cleat? Interesting question...there is no way to reach that cleat from the dock. Since I handle her a lot by myself I need an easy way to tie and un-tie her. The rear cleat is no problem, the center cleat is un-reachable from inside and the front cleat is unreachable from the dock. So necessity turned to tying off to the bow rail. I have a product that provides the perfect solution for your one man operations. http://hookandmoor.com/works/ |
|
| Author: | LVChris [ Sun Dec 28, 2014 12:09 pm ] |
| Post subject: | Re: WOT |
Quote: I have a product that provides the perfect solution for your one man operations.http://hookandmoor.com/works/[/quote] Appreciate that, but I really don't have a "problem" doing it myself. The 238 is just about the perfect size for one person. Tying off temporarily to the bow rail works well, if it ever became a problem, I'd probably just add another cleat in-between. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|