www.iFourWinns.com
https://www.smwebhead.com/phpBB3/

Looking for this
https://www.smwebhead.com/phpBB3/viewtopic.php?f=2&t=4280		 Page 1 of 1
Author:  mike_the_cobra [ Sun Aug 09, 2009 8:59 am ]
Post subject:  Looking for this
Any one know where I can get this part? It is for a Four Winns (1992) convertible top (180 Freedom). I have them on on convertible top for my 150 Freedom which I am selling, but they don't seem to come out of the tubes. I am looking only for the part that goes into the tube, the L piece that clips into the "M" bracket on the window.

Any help would be appreciated!!!! (I have tried everywhere)....

Image
Author:  M3eater [ Sun Aug 09, 2009 9:51 am ]
Post subject:  Re: Looking for this
That's probably a Taylor part. Look on-line at west marine (or others).

However, when that part broke on out 245 Sundowner, I changed to metal hardware. This just required mounting a different bracket on the windshield frame and the corresponding part on the ends of the tube. The pivot point then become a through bolt instead of the snap-in plastic button-head.

I don't remember exactly what I used, but I think it was similar to these part (below). With your set-up, where you have two tubes in the plastic socket-end, you would have to look for a different "eye" end.

Windshield mount:

Image

Tube end:

Image
Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/