www.iFourWinns.com
https://www.smwebhead.com/phpBB3/

another vdo gauge dash build
https://www.smwebhead.com/phpBB3/viewtopic.php?f=2&t=9069		 Page 1 of 1
Author:  remi_357 [ Thu Apr 12, 2012 9:40 pm ]
Post subject:  another vdo gauge dash build
here is mine i did last year. if anyone has any questions on the conversion just ask. its pretty simple


Image

Image
Author:  Celtic_Winns [ Sat Apr 14, 2012 4:56 pm ]
Post subject:  Re: another vdo gauge dash build
Wow. Nice job.
I am getting ready to rip out my VDO gauge pack from my 1995 Horizon 200. It's just junk.
I know that yours is not exactly like mine, but give me an idea of what you went though and maybe I can do something similar to get a replacement for mine.

Again, great job!
Author:  remi_357 [ Sun Apr 15, 2012 9:02 pm ]
Post subject:  Re: another vdo gauge dash build
all i did was cut a piece of ply wood to fit the original dash opening. I then fiberglassed the ply wood to the dash, sanded, then skim coated it with bondo and sanded smooth. The color on it is good old spray paint.
Author:  TX H210SS [ Sun Apr 15, 2012 10:04 pm ]
Post subject:  Re: another vdo gauge dash build
You can also use a piece of carbon fiber or thick textured plastic in a color of your choosing...a set of circular fine tooth drill bits from home depot and sandpaper to edge out holes....I've seen satin finish stainless but too shiny in sun for me...not to mention hotter than hell and expensive.
Author:  Celtic_Winns [ Sun Jul 29, 2012 4:49 pm ]
Post subject:  Re: another vdo gauge dash build
remi_357, what is the gauge just to the upper right of the oil gauge?
Also, what is the Hawkeye gauge to the right of this cluster?
Thanks.
Author:  remi_357 [ Sun Jul 29, 2012 5:43 pm ]
Post subject:  Re: another vdo gauge dash build
The gauges are oil, temp, speed, tach, volts, fuel, trim, hours. The hawk eye gauge is the depth finder
Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/