ProfitOfDoom wrote:
The boat in question is a '99 245 sundowner.
It currently has a transducer right next to the drain plug and before the speedo wheel. If I were to get a new unit,I would get the ones with down and side scan and those transducers look to be pretty long "about 12 inches" so I do not think it would work in the current position. I think I would have to come out of the are where the drive is and mount more on the outer transom,but looks like its at quite a angle. I guess I would just mount the ducer as level as possible? If you gone through this on a similar boat,Let me know how it should be done,Thanks!
If by "outer transom" you mean the extended planning surfaces (extension boxes?), you definitely do not want to mound a transducer back there... too likely to have air bubbles passing under the transducer. I would definitely mount to the primary transom. Check the directions to see if there are any limitations on how close it can be to the outdrive, but that might not matter since it probably looks slightly forward.
_________________
![Image](http://tinyurl.com/yc6eyl36)
"Knot Easy" 2000 Horizon 240 Volvo 5.7GS /SX
tow: 2017 Honda PILOT EXL-AWD
prev. boats:
'87 Chaparral 198CXL 4.3 OMC Cobra
'69 Jetstar 16ft Ski Boat, 115hp Yamaha
'68 Aluminum Jon Boat, 3hp Sears
'64 Water Wings