www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
transducer location on 2002 Funship 234 https://www.smwebhead.com/phpBB3/viewtopic.php?f=20&t=15971 |
Page 1 of 1 |
Author: | Mark11 [ Mon Jun 04, 2018 2:06 pm ] |
Post subject: | transducer location on 2002 Funship 234 |
Mounting a transom mount transducer for Lowrance fishfinder on our 2002 Finship 234. Any advice on the best location? |
Author: | EvilZ [ Mon Jun 04, 2018 11:43 pm ] |
Post subject: | Re: transducer location on 2002 Funship 234 |
I mounted the transom mount transducer on my '02 FS214 starboard of the outdrive. Depending on how far to the side you mount it, I guess you might have to compensate for the depth offset. |
Author: | chris268 [ Tue Jun 05, 2018 11:20 am ] |
Post subject: | Re: transducer location on 2002 Funship 234 |
EvilZ wrote: I mounted the transom mount transducer on my '02 FS214 starboard of the outdrive. Depending on how far to the side you mount it, I guess you might have to compensate for the depth offset. same spot on my 2002 visa 268 |
Author: | Mark11 [ Tue Jun 05, 2018 12:16 pm ] |
Post subject: | Re: transducer location on 2002 Funship 234 |
chris268 wrote: EvilZ wrote: I mounted the transom mount transducer on my '02 FS214 starboard of the outdrive. Depending on how far to the side you mount it, I guess you might have to compensate for the depth offset. same spot on my 2002 visa 268 Thanks for the info! The instructions say to do starboard side also because of the prop rotation, I am a little concerned because our boat has the counter-rotating dual prop. |
Author: | EvilZ [ Tue Jun 05, 2018 1:31 pm ] |
Post subject: | Re: transducer location on 2002 Funship 234 |
I'm no expert, but I think the concern is that the transducer could create air bubbles which could affect the performance of the props. With it mounted to the side (either), I wouldn't expect this to be an issue. There are some videos out on youtube which may be of some help, but even those can contradict each other. My $0.02 - mount it to starboard, line it up between the chines and have the bottom of the transducer below the boat so that it has clean water. Don't forget to use sealant in the screw holes! Erik |
Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |