So this one really has me stumped.
My gas gage always reads 1/2 of a tank (it used to work right after we got the boat but no more). The needle will move up and down as the boat rocks because of waves but no matter how full or empty the tank is it always shows 1/2 full.
I went to my Seloc manual and it says I should have three wires going to the sender on the gas tank. I only have 2 and it looks like this gage only uses two wires. I took the sender out and manually moved it through its whole wrange of motion.
It is like the center of the gage is wrong. The highest I can make it go is 1/2 but if I move the sender all the way "down" I move the needle on the dash WAY lower than the "E" mark.
Suggetestions? I can't really use the trouble shooting tips in the manual since I don't have the same # of wires as the stock unit.
Photos:
http://i1067.photobucket.com/albums/u42 ... eacb04.jpghttp://i1067.photobucket.com/albums/u42 ... eacb04.jpg