I have the one pictured on the bottem it is easy to install and works great
| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Teleflex Side Mount Controls https://www.smwebhead.com/phpBB3/viewtopic.php?f=21&t=12544 |
Page 1 of 1 |
| Author: | bvlmv [ Wed Jan 08, 2014 11:15 pm ] |
| Post subject: | Teleflex Side Mount Controls |
Hi, Just want to know if someone has successfully replaced their original side mount control with the following. http://www.iboats.com/Teleflex-Side-Mount-Controls/dm/cart_id.656415613--session_id.570857913--view_id.49233 I have a 99 Horizon 220 Thanks! |
|
| Author: | LouC [ Thu Jan 09, 2014 1:17 am ] |
| Post subject: | Re: Teleflex Side Mount Controls |
I was going to do that this spring (bought the control and all nice one) but after I adjusted the transom shift cable it shifted so well I decided to wait till something goes wrong within my OE OMC control. Also removing the side panel in my boat is a big project. Kept the control cecsuse you can't get parts for the OMC ones, but they were very good for it to last this long. |
|
| Author: | taz42169 [ Fri Jan 10, 2014 6:00 pm ] |
| Post subject: | Re: Teleflex Side Mount Controls |
I have a top mount....did throttle and transmission. Piece of cake! |
|
| Author: | neutron [ Sat Feb 08, 2014 8:54 am ] |
| Post subject: | Re: Teleflex Side Mount Controls |
I have the one pictured on the bottem it is easy to install and works great
|
|
| Author: | LouC [ Sun Feb 09, 2014 12:15 pm ] |
| Post subject: | Re: Teleflex Side Mount Controls |
That really looks great! How hard was it to remove the side panel to install it? I was going to do this as I said but then after I adjusted the shift cable it was much better. But sooner or later something will happen with the old control and I will have to change it since the internal parts like trim switches are no longer available. On my boat the big coaming side panel is held on by threaded studs that go through the glass and nuts on the inside of the glass. It looked to me like I'd have to cut them off since the studs were just spinning when I tried to remove the nuts. |
|
| Author: | neutron [ Sun Feb 09, 2014 12:47 pm ] |
| Post subject: | Re: Teleflex Side Mount Controls |
when I take my 2-way radio box out I have a large opening to access all the cables and wiring so no panels had to be removed. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|