| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Engine Warning Kit Install https://www.smwebhead.com/phpBB3/viewtopic.php?f=21&t=12786 |
Page 1 of 1 |
| Author: | deafwish [ Wed Apr 16, 2014 5:58 am ] |
| Post subject: | Engine Warning Kit Install |
Hi all, Planning on fitting a Cole-Hersee (M40177BP) warning buzzer kit to my 5.7GL over the winter break. http://www.colehersee.com/home/item/cat/232/M-40177BP/ Any installation tips (sensor locations) would be greatly appreciated, if anyone else has fitted one? Cheers. |
|
| Author: | DaleG [ Wed Apr 23, 2014 9:26 am ] |
| Post subject: | Re: Engine Warning Kit Install |
I cannot help a lot, but last winter installed a similar system after overheating an engine and then rebuilding it. I put in a temperature switch, the same buzzer, and an LED light in the gauge cluster. In my mind the biggest problem is where to put the sensors. On my engine -- an EFI engine -- all the normal locations seemed to be used. I ended up putting the temp sensor in place of a large plug on the water pump itself -- I am not sure if this is a good location and have my doubts. Good luck on yours. |
|
| Author: | deafwish [ Wed Apr 23, 2014 5:02 pm ] |
| Post subject: | Re: Engine Warning Kit Install |
Thanks for the response, mate. Might you be able to take a photo of the location you're referring to? Did you fit a low oil pressure switch? Cheers. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|