www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
SX Cobra Trim Pump - Down & No Up! https://www.smwebhead.com/phpBB3/viewtopic.php?f=21&t=12820 |
Page 2 of 2 |
Author: | deafwish [ Thu May 01, 2014 3:20 am ] |
Post subject: | Re: SX Cobra Trim Pump - Down & No Up! |
After spending another 3 hours on this, there is a break in the 'UP' trigger/ switch wire, somewhere under the floor! I dismantled the handle, cut & pulled the switch wires through to under the dash and tried hotwiring the switch wires. The down works perfectly, but not the up! I'll buy some 16AWG twin core cable & perform a new run down the starboard side of the boat to the new solenoid. What a pain in the @ss! |
Author: | LouC [ Sat May 03, 2014 8:27 am ] |
Post subject: | Re: SX Cobra Trim Pump - Down & No Up! |
Glad you found the break. Knew it had to be somewhere. Only thing that made sense and you don't need to change or work around that relay pack..... |
Author: | SteveinLA [ Sat May 03, 2014 9:43 am ] |
Post subject: | Re: SX Cobra Trim Pump - Down & No Up! |
Hi Deafwish, I wrote a long detailed response. I must have done something wrong because when I tried to post it, it disappeared. Hmm. Anyway, thanks for the tip. I read about your wiring trouble. I'm glad you figured it out. If mine begins to do anti-social things, I'll know where to start looking. Cheers! Steve Thanks to everyone who has chimmed in with advice and opinions. |
Author: | deafwish [ Sat May 03, 2014 7:44 pm ] |
Post subject: | Re: SX Cobra Trim Pump - Down & No Up! |
For the record, I didn't find the break - I ran a new figure 8 cable to the pump. |
Author: | LouC [ Sat May 03, 2014 8:09 pm ] |
Post subject: | Re: SX Cobra Trim Pump - Down & No Up! |
Sometimes that's the best way |
Page 2 of 2 | All times are UTC - 6 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |