www.iFourWinns.com
https://www.smwebhead.com/phpBB3/

LED's to replace courtesy light
https://www.smwebhead.com/phpBB3/viewtopic.php?f=21&t=13954		 Page 1 of 1
Author:  Flyindutchman [ Tue Apr 28, 2015 1:01 pm ]
Post subject:  LED's to replace courtesy light
Would anyone be able to recommend the specs of LED's suitable for installation throughout the interior of my H200. Connectors and switch suggestions would be great too.

Would just do under dash and in side storage pockets I think so 4 strips likely. I know a number of you have done this and could save me from ordering inferior product. Any recommendations on suppliers would be good too - looking on eBay currently and there's just tons to choose from...

Thanks for any info.
Author:  NiagaraChillin [ Thu Apr 30, 2015 5:51 am ]
Post subject:  Re: LED's to replace courtesy light
I used these for the side pocket storage area. 3 years on, still going strong. http://www.autozone.com/lighting-led-and-neon/led-lighting/alpena-flexled-light/60049_0_0/
Author:  Thalasso [ Thu Apr 30, 2015 10:59 am ]
Post subject:  Re: LED's to replace courtesy light
Don't know of any LED lighting made in the U.S. All of it is from China.
Just make sure there waterproof. At least IP65rated. They will come either in strip or rope. Depending on what type of surface they are getting mounted on will depend weather you need brackets/clips.
Wire them hot and control them with a key fob.
Just installed Wireless Remote Controller RF Dimmer for 5050/3528 Single Color LED Strip Lights
Author:  rpengr [ Mon May 04, 2015 8:54 am ]
Post subject:  Re: LED's to replace courtesy light
This is interesting:
(12v LED color controller, touch control)
http://www.mcmelectronics.com/product/25-5945?green=9b1e7d902-21f1-6806d4-c44f-ed070582975
They sell LED strips also.
Author:  NickH [ Wed May 27, 2015 4:07 pm ]
Post subject:  Re: LED's to replace courtesy light
I replaced the 4 courtesy lights with these from Whelen Engineering in Ct. They're made in America, have a 5-Year warranty and are very bright. I work for an emergency vehicle up-fitter and we use these on Police, Fire, EMS, public works vehicles, transit busses, etc. so they're plenty rugged.

Coincidentally, they matched the mounting screw hole pattern of my 18 year old OEM lights...

http://www.whelen.com/pb/Automotive/ProductSheets/Lightheads/3inch_Round_Super-LED_Lighthead.pdf

OFF:
Image

RED:
Image

Image

Image

WHITE:
Image

Image

Image
Author:  ThaScoobs [ Mon Jun 01, 2015 10:49 am ]
Post subject:  Re: LED's to replace courtesy light
I have bought cheap LED sets and expensive LED sets for different projects. I have not noticed much in quality differences between them. Just make sure you get waterproof or sealed lights and you should be fine.

Thalasso wrote:
Don't know of any LED lighting made in the U.S. All of it is from China.
Just make sure there waterproof. At least IP65rated. They will come either in strip or rope. Depending on what type of surface they are getting mounted on will depend weather you need brackets/clips.
Wire them hot and control them with a key fob.
Just installed Wireless Remote Controller RF Dimmer for 5050/3528 Single Color LED Strip Lights


The key fob controllers are nice if you are not wiring anything near a switch. I use one for my drain plug lights and love it.
Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/