www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
Engine ground studs on 2004 VP small block V8s https://www.smwebhead.com/phpBB3/viewtopic.php?f=21&t=5145 |
Page 1 of 1 |
Author: | Graham R [ Thu Feb 25, 2010 12:30 pm ] |
Post subject: | Engine ground studs on 2004 VP small block V8s |
Last year, following severe electrical problems, I posted this in case anyone had similar issues: Quote: There are two ground studs, the first one on the block, the second on the starter; Unless you know it's there, it's difficult to see the second until the first is stripped back. These use a mix of stainless and mild steel nuts and washers, A/F this time, not metric. The engine stud has the 2 battery leads, plus a lead that goes to the alternator ( I think!). Also the ACP and Neutrasalt ground wires. The other stud takes the ground wires from the FW engine compartment harness. This weekend whilst changing the bilge blower I found out there are actually 3 ground studs, not 2 ! There are the 2 on the starboard side, plus there is another one on the port side. As standard, it has 2 cables going to the engine electronics. Then another attached which goes to the transom shield and one to the trim tab motor. Again, using a mix of mild steel and stainless nuts and I found some corrosion evident ( no protective grease at all). Maybe of use to someone chasing down ground issues. Graham |
Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |