www.iFourWinns.com

Yup and yup.

Wires are starting to get a tad bit corroded. The other night I had to fidget with the wires on the starter switch because all the gauges turned off (but boat ran fine).

If I dip under the helm and clean all the contacts, is there something I can spray it with to cover the bare metal?

_________________
1981 Columbia 8.7
2015 Yamaha FZR - 87mph - sold
2006 Yamaha GP1300R - sold
2003 Chaparral 215 SSI - sold
2009 Stingray 195CS - sold
2000 Four Winns H180 - sold
1976 O'day Daysailer II - sold
Rick's Four Winns H180 Mods/Upgrade Thread

http://www.amazon.com/Permatex-22058-Di ... B000AL8VD2

Every boater should have a tube in their bag IMO.

_________________


Mike
2005 Four Winns 230/240
VP 5.7GXi/DP
1998 F-150 XLT
Boat Pic

THATS IT!! You should try to clean the connectors/contacts first. Wire brush, sand paper, file, andthing that will clean it. Than coat it with the grease.

I went to West Marine and tried their stock Hella LED white light and it worked great. I was a little concerned about fitting in the original hole and it just fit. I sealed the connections with a plastic crimp connector and a portable heat sealer. There is less light but I like it better for night vision.

_________________
07 Tiara Sovran 4300
07 338 Vista - SOLD