Hi lads,
I have this wheel on my boat i just bought. The whole center plastic cover is missing. Does anyone know the part numbers?
I believe its a Ultraflex brand. The top one I believe is the one. Mine on the bottom pic.
2006 model..
| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| four winns steering wheel https://www.smwebhead.com/phpBB3/viewtopic.php?f=22&t=8243 |
Page 1 of 1 |
| Author: | Dropdprpls10 [ Tue Aug 16, 2011 8:00 am ] |
| Post subject: | four winns steering wheel |
i just bought a used 1992 four winns 220 horizon.. boat is in awesome condition.. i did notice that the steering wheel is broken almost in half.. the guy who owned it must have pulled on it pretty hard over a wake or something.. the one side is held by the covering.. i would like to replace it with the same color and kind if i can.. the center cap is good still.. its a light gray ish color.. if anyone knows where i can find an exact replacement i would be very thankful!! David |
|
| Author: | JordanFTW [ Tue Aug 16, 2011 2:29 pm ] |
| Post subject: | Re: four winns steering wheel |
OEM here: http://www.fourwinns.net/partbook/ Take the part # to dealer... However I would just buy something else off ebay if I were you. |
|
| Author: | LouC [ Tue Aug 16, 2011 3:50 pm ] |
| Post subject: | Re: four winns steering wheel |
I took off my OE wheel and put on a destroyer style wheel with a spinner knob, which is a lot more functional than the OE one was. |
|
| Author: | Dropdprpls10 [ Wed Aug 17, 2011 6:44 am ] |
| Post subject: | Re: four winns steering wheel |
i checked out you link jordan.. but it only goes back to 1996.. i have a 1992.. unless you think they used the same part in that year? |
|
| Author: | ric [ Wed Aug 17, 2011 11:33 am ] |
| Post subject: | Re: four winns steering wheel |
Any wheel with a 3/4 tapered hole (all boat wheels) or you can ebay an adapter and install any standard aftermarket steering wheel. I've been fancying a 60's style wood ford mustang style. Or you could go all out and get a new 2012 Horizon wheel. |
|
| Author: | captkevin [ Wed Aug 17, 2011 1:43 pm ] |
| Post subject: | Re: four winns steering wheel |
Most newer boats don't use the 3/4" tapered shaft steering wheels but a hub system |
|
| Author: | ric [ Wed Aug 17, 2011 3:46 pm ] |
| Post subject: | Re: four winns steering wheel |
Well, whatever your boat has... you can buy adapters. Like this: http://shop.vendio.com/crowderscustomiz ... 1313567763 http://cgi.ebay.com/ebaymotors/Boat-3-4 ... 687wt_1165 |
|
| Author: | Graham R [ Thu Aug 18, 2011 2:45 am ] |
| Post subject: | Re: four winns steering wheel |
The original steering wheel may well be attached to an adaptor already; they were on both my 1999 and 2004 boats. The centre of the 2004 one for sure is splined, not a taper/key. Both wheels were attached to the adapters with 6 countersunk allen bolts, in a standard PCD spacing I imagine. So, an aftermarket wheel could in my case have been fitted to the original adapters. I did buy an aftermarket "Victor" leather covered wheel for my 2004 boat; it turned out to have a 5 hole setup, not a 6 hole ! it just required some holes redrilling in the wheel, the PCD was the same. Graham |
|
| Author: | Giffo [ Wed Mar 21, 2012 1:18 am ] |
| Post subject: | Re: four winns steering wheel |
Hi lads, I have this wheel on my boat i just bought. The whole center plastic cover is missing. Does anyone know the part numbers? I believe its a Ultraflex brand. The top one I believe is the one. Mine on the bottom pic. 2006 model..
|
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|