www.iFourWinns.com

I would copy the instructions found when I swapped the seats, but they seem more confusing than actually looking under the seat. Sun I looked under each seat, and found one retaining clip/screw holding them in. Remove the screw/clip with a short phillips screw driver and lift the seat straight up. I then switched p/s (so the handles are pointing inboard instead of toward the trim) and re-installed the screw/clip making sure the seat is secure. I find it is much easier to swivel the seats with the bolsters up and moving them slightly forward first, then rotating.

I'm hoping for your sake the '07 H210 and H200 use the same assembly.

_________________
Walt B
"Debt-Charged"
Black '07 H210SS
6.2L Bravo One turning a 21P HIFive
Wakeboard Tower with Perfect Pass Stargazer version
Missouri River; Kansas City, Mo.

Hey guys,

Thanks for the tips on photo upload - I used photobucket - super easy - well a heck of a lot easier than fixing a Swivel Seat...

Here are the shots - you can see in one the black tab that I am taking about - does this thing come out or should I just take the to the dealer.





Thoughts anyone?

Dack Heslop
Toronto, ON Canada
2008 Four Winns H180
Volvo Penta 3.0 GL/SX 135 h

_________________
Dack Heslop
Toronto, ON Canada
2008 Four Winns H180
Volvo Penta 3.0 GL/SX 135 h

I had the exact same problem on my H210 and after tinkering with it for an hour or so called FWs. They said that if that if the cable comes out of the keyhole slot it can not be repaired. I was a little incredulous, but they sent me a new assembly under warranty. I did not argue with them. Personally I think the seats leave some areas to be desired. As with the comments above, they are hard to work with, the levers get into hardspots and the cables stretch (or something) to the point that you have to put too much force on them and then the cable comes out. Hmmm.

Hope somebody is still reviewing this thread.

I have a 2007 H200. I would like to swivel the seats but notice that they hit the outer trim. Either seats are too low or trim is too high. Anybody found a fix for this yet. Maybe removing the trim will work. Maybe raising the seats somehow will work. I thought I would ask before I start taking the seats off.

Thanks

I have aftermarket seats in my old '88 so this may not apply, but I found that if the seats are slid back you can't swivel them, to do that you have to slide them forward. When they are slid backward they need more room to pivot sideways.

_________________
88 Four Winns 200 Horizon
4.3 OMC Cobra-4bbl
2002 Walker Bay 10/2012 Suzuki 2.5
2008 Walker Bay 8

1998 Jeep Grand Cherokee 4.0/Selectrac
2007 Jeep Grand Cherokee 5.7 Hemi/Quadradrive II