www.iFourWinns.com

I've looked at my drive constantly over the years looking for the zerk to grease the kimball bearing but cannot seem to locate it. I'm sure it's right under my nose but want to get some grease added while i'm about to get the winterization project going

thanks in advance!

_________________
2006 Nissan Titan SE 6" Lift
2000 Four Winns 190 Horizon 5.0GL

Well thats the problem; you should be looking for a gimble bearing not a Kimble bearing, just kidding. The zerk is on the right hand side of the transom mount.

_________________
88 Four Winns 200 Horizon
4.3 OMC Cobra-4bbl
2002 Walker Bay 10/2012 Suzuki 2.5
2008 Walker Bay 8

1998 Jeep Grand Cherokee 4.0/Selectrac
2007 Jeep Grand Cherokee 5.7 Hemi/Quadradrive II

On the transom shield, the same height as the trim sender, unless it has had a "sealed for life" ( i.e. sealed for short life) bearing fitted, in which case the tube may be blanked off

Cause its not on the "drive".... like Graham and Lou said, its on the transom mount/shield, right hand side (as you look at the stern/transom). Now, also like Graham said, it could be a non-greasable gimble. What year is your VP SX?

_________________

1996 205 Sundowner DLX
5.0FL Volvo SX Cobra
Tow Veh: 2012 Nissan Frontier Pro-4X

Here's a picture of my 1996 sx drive and the location of where the grease zerk is located on the transom shield.

_________________
'96 200 Horizon 5.8l VP/SX