FEDERAL LAW
183.568 - Anti-siphon protection
Each fuel line from the fuel tank to the fuel inlet connection on the carburetor must:
(a) Be above the level of the tank top; or (b) Have an anti-siphon device or an electrically operated fuel stop valve:
(1) At the tank withdrawal fitting; or (2) Installed so the line from the fuel tank is above the top of the tank; or
(c) Provided that the fuel tank top is below the level of the carburetor inlet, be metallic fuel lines meeting the construction requirements of Sec. 183.538 or "USCG Type A1" hose, with one or two manual shutoff valves installed as follows:
(1) Directly at the fuel tank connection arranged to be readily accessible for operation from outside the compartment, and (2) If the length of fuel line from the tank outlet to the engine inlet is greater than 12 feet, a manual shutoff valve shall be installed at the fuel inlet connection to the engine.
"Anti-siphon protection" is a term applied to the means of preventing the siphon action of permitting fuel to continue to flow out of the fuel tank in the event there is a break or rupture in a fuel distribution line, or if a fitting in the fuel line loosens, creating a leak.
"Anti-siphon protection" may be accomplished by one or more of the following methods:
(a) Keep all parts of the fuel line from the fuel tank to the fuel line connection at the carburetor above the level of the top of the fuel tank. The tank top level is determined with the boat in its "static floating position." Practically, the fuel pump and fuel filter(s) must also be above the tank top.
(b) Install an anti-siphon device at the tank withdrawal fitting. The fuel distribution line may then run below the level of the tank top. A filter may be installed between the fuel tank withdrawal fitting and the anti-siphon device.
The idea here is if any part of the fuel line drops below the top of the tank, it is possible for a leaking fuel line to siphon fuel out of the tank (keep in mind the fuel pick up in the tank goes almost all the way to the bottom of the tank). So it's different than the hose in bucket siphon scenario unless the hose goes all the way down to the bottom of the bucket and remains covered in liquid.
As an example during Hurricane Sandy we could not get gas, at least easily for about 2 weeks. I had about 35 gallons of gas for the generator (no electric for 2 weeks). After the first week I decided to siphon gas out of the tank of the boat, which I had filled up about a month before. I removed the rear seat, removed the hatch for the tank and then the cover for the gauge sending unit. I had a small hand pump hooked up to some fuel line. The gas can was on the ground, as soon as I got a siphon going with the line going to the bottom of the tank, I did not have to pump anymore and gas was siphoning faster than you'd think. I would up taking about 30 gallons out of the boat and that was enough to keep us going another week or so.
_________________ 88 Four Winns 200 Horizon 4.3 OMC Cobra-4bbl 2002 Walker Bay 10/2012 Suzuki 2.5 2008 Walker Bay 8
1998 Jeep Grand Cherokee 4.0/Selectrac 2007 Jeep Grand Cherokee 5.7 Hemi/Quadradrive II
|