www.iFourWinns.com

Four Winns Horizon 200. My ignition switch has become loose, such that when I turn the key, the entire housing turns with it, and wont allow the engine to start. I have to physically hold the housing in place when I turn the key, or reach underneath and hold the entire ignition unit in place while I turn the key on or off.

Has anybody dealt with this, and have any easy solutions? I don't see a nut on the back side that can be tightened up.

Thanks.

There should be a relatively thin nut behind the dash, I am not sure how it would be held in place otherwise. For example:



Are you sure there is no nut?

_________________
NEW - 2000 Cobalt 246 w/454 Magnum 385HP | SOLD - 2000 FW Horizon 180 LS w/5.0Gi 250HP Volvo Penta

Thanks, Gott. I better look closer. It does seem like there has to be a nut under there.

It should look something like this:

https://www.dropbox.com/s/jwtmlf3upmwja ... h.jpg?dl=0

_________________
88 Four Winns 200 Horizon
4.3 OMC Cobra-4bbl
2002 Walker Bay 10/2012 Suzuki 2.5
2008 Walker Bay 8

1998 Jeep Grand Cherokee 4.0/Selectrac
2007 Jeep Grand Cherokee 5.7 Hemi/Quadradrive II