www.iFourWinns.com

I have the back to back loungers in my 200 horizon. I'm getting ready to sell it and I want to clean inbetween the seats. I've never put them down before and I'm apparently missing something. I see the lever in the front and the front seat goes out passed where the lever catches but I can't get the back seat to slide out. It goes out a little and catches on something. It's probably stoping about a 1/4 of the way down.

Is something wrong or is there another handle I'm missing? Like I said I've never used them before so I'm not sure if something is wrong or I'm not doing something.

When I had a 1996 200 Horizon with that seating (after extending the front) you had to lift up on the bottom of the rear facing seat and pull it up and out. There was a funky hinge under there. It took some muscle and I suspect if yours have never been out it will be difficult. Lift it up and you can see it.

_________________
Former owner of:
1996 Four Winns Horizon 200 5.8L VP
2006 Four Winns Horizon 260 8.1L VP
2007 Sea Ray 290 Sundancer

Current boat
2004 Sea Ray 290 Sun Sport Twin 350 Mags

I've done that part and I know what you're talking about. I feel if I put any more pressure on that bar I'm going to break it. Maybe some WD40 or something.

I had a hard time collapsing the drivers side until I pulled the seat further forward. It seemed that it was catching on the seat adjustment when it was all the way back.

_________________
-Rob.


Current boat: 2011 Yamaha AR210
Previous boat: 1998 Horizon RX 4.3GL SX