www.iFourWinns.com

So I was able to add the IPOD adaptor to my stereo. To get to the back of mine you had to take the dash off. It wasn't bad. Only 3 bolts. There was two sets of RCA hook-ups in the back. I hooked into one of them and came through sounding good. I put everything back together and only then noticed that it is only coming through my front speakers in the bow and not the my other two. Buddy of mine said that I needed to get an attachment so hook into both sets of RCA hook-ups because it is two seperate channels. Does this sound right? I'm going to tear back into it Sunday morning. Going to be too nice tomorrow to miss time on the water working on a project like this. Thanks for all the help.

_________________
2005 200 Horizon 5.0 MPI 260hp
2010 Chevy Silverado 1500
Carlinville, IL

No. There should not be a front & rear input. Make sure you are plugged in to the same red/white RCA cable. The deck will plit the signal to 4 speakers. Sounds like either one of the RCAs came off upon re-installation, or you plugged one to the input & the other into the pre-out.

_________________

H210SS 6.2
F150 Platinum

Ok, Finally got everything working. Had to take the dash back off and found that there was three RCA cable not two like I posted earlier. One was the preouts. One set only went to the front two speakers for some reason and then the third set was the one I was looking for. Sounds great. Thanks for the help everyone.

_________________
2005 200 Horizon 5.0 MPI 260hp
2010 Chevy Silverado 1500
Carlinville, IL