| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Drive won't trim up. https://www.smwebhead.com/phpBB3/viewtopic.php?f=3&t=13029 |
Page 1 of 1 |
| Author: | AlexJ [ Sun Jun 15, 2014 8:36 pm ] |
| Post subject: | Drive won't trim up. |
I can hear the motor run when I press the down switch but the up switch went dead. It worked before I put it in the water. Is it a fuse and where might it be? |
|
| Author: | jontmiller [ Mon Jun 16, 2014 6:30 am ] |
| Post subject: | Re: Drive won't trim up. |
On mine there are two relays on the trim motor (look for the reservoir) I have replaced both of mine but they still get sticky....a wack (tap) with the handle of a screwdriver works every time. Relays are cheap and probably should be replaced . |
|
| Author: | DaleG [ Sun Jun 22, 2014 4:08 pm ] |
| Post subject: | Re: Drive won't trim up. |
If you have the TWO relays side by side at the pump ==== swap them ---- you should then have up and no down ---the opposite issue. I just went through this on my boat, and the issue was corrosion of the connections that the relays plug into. thx Dale |
|
| Author: | AlexJ [ Sat Jun 28, 2014 9:12 am ] |
| Post subject: | Re: Drive won't trim up. |
I found the problem. I researched other posts and found the plug mounted on the engine was partially disengaged. Apparently there is supposed to be a clamp or something holding it together and I found none. Any ideas on how the fabricate one? |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|