| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| 2006 h220 5.7 280 HP volvo https://www.smwebhead.com/phpBB3/viewtopic.php?f=3&t=13043 |
Page 1 of 1 |
| Author: | atlmover [ Mon Jun 16, 2014 10:48 pm ] |
| Post subject: | 2006 h220 5.7 280 HP volvo |
What is the max rpm on the 5.7 Volvo with 280hp? Its an 06 model 220 |
|
| Author: | GottWhat [ Mon Jun 16, 2014 11:00 pm ] |
| Post subject: | Re: 2006 h220 5.7 280 HP volvo |
http://www.fourwinns.com/customer-servi ... nuals.aspx Should be in the manual for your boat. See link above. |
|
| Author: | GottWhat [ Mon Jun 16, 2014 11:00 pm ] |
| Post subject: | Re: 2006 h220 5.7 280 HP volvo |
Also the fast facts catalog here: http://www.fourwinns.com/customer-service-catalogs.aspx |
|
| Author: | GottWhat [ Mon Jun 16, 2014 11:00 pm ] |
| Post subject: | Re: 2006 h220 5.7 280 HP volvo |
I only saw the 280 hp 5.7 in the 2006 fast facts and it stated max RPMs to be 4600-5000. |
|
| Author: | atlmover [ Wed Jun 18, 2014 8:15 am ] |
| Post subject: | Re: 2006 h220 5.7 280 HP volvo |
Thanks for the replies. I guess I'll just assume its 4600 and listen close to the motor. It was pushing 5000 and I had to back it down to keep from going over. Running g about 42-45mph. I'm guessing I need a new prop. My factory 19 is chewed up pretty good. I heard a 17 pitch 4 blade is the ticket. I'd really like to run 50 and have a good hole shot. |
|
| Author: | GottWhat [ Wed Jun 18, 2014 8:37 am ] |
| Post subject: | Re: 2006 h220 5.7 280 HP volvo |
atlmover wrote: Thanks for the replies. I guess I'll just assume its 4600 and listen close to the motor. It was pushing 5000 and I had to back it down to keep from going over. Running g about 42-45mph. I'm guessing I need a new prop. My factory 19 is chewed up pretty good. I heard a 17 pitch 4 blade is the ticket. I'd really like to run 50 and have a good hole shot. I am still new here but I don't think going to a 4 blade 17 pitch is going to help you with top speed. It will help with the hole shot but I think your top end would be lower. Maybe someone else can chime in? If you have the VP5.7Gi with 280 HP, the fast facts sheet says it came with a stainless steel 3 blade prop size 14 3/4 x 19 and had a top speed of 47-50. The GXi 5.7 has 320 HP, the same prop but a top speed of 49-52. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|