Not sure why but there is a screen filter on the one port
| www.iFourWinns.com https://www.smwebhead.com/phpBB3/ |
|
| Help with carb https://www.smwebhead.com/phpBB3/viewtopic.php?f=3&t=14351 |
Page 1 of 1 |
| Author: | on1wheel01 [ Mon Aug 03, 2015 7:19 pm ] |
| Post subject: | Help with carb |
Trying to find my running issues. 93 four winns 190, 302 ford new engine runs great except under load. It spits and sputters, figure carb needs attention timing is also set right on. I have what I figure is a vac line coming from rear of carb but I see no port for it to go to. Any ideas |
|
| Author: | deafwish [ Mon Aug 03, 2015 10:03 pm ] |
| Post subject: | Re: Help with carb |
Can you take a photo of the port? It's likely for the PCV, but could also be for the electric choke. |
|
| Author: | on1wheel01 [ Tue Aug 04, 2015 7:49 am ] |
| Post subject: | Re: Help with carb |
Not sure why but there is a screen filter on the one port
|
|
| Author: | on1wheel01 [ Tue Aug 04, 2015 12:53 pm ] |
| Post subject: | Re: Help with carb |
Just ordered a carb rebuild kit also. Hopefully be here in a few days |
|
| Author: | deafwish [ Tue Aug 04, 2015 5:14 pm ] |
| Post subject: | Re: Help with carb |
The brass port with the screen is not actually a port - It is for the electric choke & nothing attaches to it. You'll have a PCV that should attach to a rocker cover, a small diameter hose to the choke and a carb' return line that goes to the mechanical fuel pump. Download the Holley manual for a 2300. |
|
| Author: | on1wheel01 [ Sat Aug 08, 2015 1:37 pm ] |
| Post subject: | Re: Help with carb |
I do have a line from the fuel pump but it's not hooked up to anything |
|
| Author: | on1wheel01 [ Sat Aug 08, 2015 6:09 pm ] |
| Post subject: | Re: Help with carb |
Well plugged the port in the rear . And put carb on. It's running horrible. Could it be because I plugged the port |
|
| Author: | on1wheel01 [ Sun Aug 09, 2015 3:56 pm ] |
| Post subject: | Re: Help with carb |
Okay unplugged the port and also i found the accelerator was put in backwards. SO now no more black smoke and loading up. But I still have the high rpm bogging. Im going to wire in a spare tach and mount on side until I order the correct tach. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|